User's Manual

Battery Installation

Programming

Digital Keypad

Your access code can be a single press of one or more

buttons at the same time. Your access code can be a mi-

nimum of 3 entries or maximum of 6 entries.

Step 1:

Open the unit with the backup key provided or

by using the factory default code. The factory default

code is a single sequential press of 1-2-3-4.

Step 2:

Locate the Learn button next to the battery

compartment on the interior roof of the unit.

Step 3:

Press and hold the Learn button. A beep will

sound and the light will turn green and remain illumina-

ted. This will indicate that the enrollment procedure has

been initiated.

Step 4: The indicator light will remain activated as you

enter the new access code. The code can be a minimum

of three entries or maximum of six entries.

Step 5: Press and hold the Learn button a second

time until the indicator light beeps, turns soild red

and remains illuminated, then release.

Product Features

(For Digital SpeedVault Only)

Always hold the battery connection cap while disco-

nnecting or attaching a new battery. Do not pull on

the power cables as this could cause the power supply

to become disconnected from the lock.

Step 1: Open the unit using the backup keys provided.

Step 2:

Locate the battery compartment on in the

interior panel. Connect the recommended 9V alkaline

battery following the Positive (+) and Negative (-) guides

on the connecting cap on the plug-in cable inside the

battery holder.

Step 3: When the battery is connected you will hear a

single beep signaling that the unit is powered.

Step 4: After you have connected the battery to the

cable you will need to reposition the battery into the

holder for a secure t.

*The lock manufacturer highly recommends the

use of either a Duracell or Energizer 9V alkaline

battery with an expiration date of 5 years into the

future.