User Guide

ManualsBrandsGunVault ManualsGun & Ammunition Storage & SafesGunVault SVB500 Speedvault Biometric combination Black

Battery Installation

(For Biometric Unit Only)

New units are set in DEMO mode, meaning the unit

can be opened without a ngerprint by pressing the

Start button. The rst two ngerprints enrolled are

the administrators, they allow the enrollment of

additional users.

Step 1: Open the unit with the backup key provided

or by pressing the Start button located on the keypad

of the unit.

Step 2: Locate the “Learn/Mute” button next to

the battery compartment on the interior roof of

the unit.

Step 3: To enroll your rst and second administra-

tor ngerprint, press and release the Learn/Mute

button.The unit will beep once and the indicator light

will begin to ash green indicating that your unit is

now in learn mode. If the indicator light stops

ashing after you have pressed the Learn/Mute

button then you have been timed out and will need

to press the button again.

(BIOMETRIC UNIT ONLY)

1. Indicator Light

2. Start Button

3. Internal Courtesy Light

(Inside the unit)

4. Learn/Mute Button

(Inside the unit)

5. Delete Button

(Inside the unit)

6. Battery Compartment

7. Bumper Bracket

8. Mounting Bracket

9. Swipe Scanner

10. Keyport

11. Wood Screws

12. Thumbscrew

13. Backup Keys

The lock manufacturer highly recommends the use of either

a Duracell or Energizer 9V alkaline battery with an expiration

date of 5 years into the future.

Step 1 :

Open the unit with the backup keys provided

and locate the battery compartment on the interior roof

of the unit.

Step 2:

Open the interior battery compartment

cover and remove the battery plug-in cable.

Step 3: Insert the recommended 9V alkaline battery,

following the

Positive (+) and Negative ( - ) guides on the

cable.

Step 4:

When the battery is connected you will hear a

single beep, signaling that the unit is powered.

Step 5:

Place the battery into compartment and reinsert

compartment cover.

When installing or replacing your battery, always hold the

battery connecting cap while disconnecting or attaching.

Do not pull on the power cables, this could cause the power

supply to become disconnected from the lock.

Product Features

Programming For

Administrator Fingerprint

(For Biometric Unit Only)