User Guide

Step 1: Open the unit by using either your backup keys
or current access code and locate the Learn button, on the
interior roof of the unit.
Step 2: Use steps (3-7) in the “Programming Digital
Keypad” section to change your current combination.
Step 3: Now you have successfully reprogrammed your
safe.
SpeedVault must be mounted at a 90° angle as the door
is gravity operated. The unit can be mounted from the
left, right or back side using the provided mounting holes.
Entering an invalid access codes triggers the Tamper
Detect feature.
Resetting Passcode
Digital Keypad
Low Battery
Warning Indicator
Tamper Detect Feature
Installing Digital
SpeedVault
Step 1: Press and hold down buttons ‘2’ and ‘3’ for
ve seconds to initiate the Tamper Detect indicator.
Step 2 : If tampering has been detected, the indicator
light will remain red until buttons ‘2’ and ‘3’ are
released.
Step 3: If tampering was not detected, the indicator
light will remain green until buttons ‘2’ and ‘3’ are
released.
Step 1: When you enter the correct combination and
the battery is low, the indicator light will ash red and
beep six times. Depending on the low battery level, the
unit may sound when releasing the lock. If the battery
level is too low, the indicator light will start to ash red and
beep continuously until the battery is removed from the
unit. If the battery in the unit is completely depleted, you
will hear only a light humming sound.
Security Sleep
Mode Feature
Step 1: After six incorrect entries the Security Sleep
Mode feature will be triggered and will lockout any
new keypad entries for two minutes. When Security
Sleep Mode is active and a button is pressed the
indicator will ash red and beep three times.
Step 2: To verify if the "Security Sleep Mode" is now
deativated, after (2) two minutes have passed test your
unit by slowly typing in your combination. If the
indicator light ashes green your combination has
been accepted and the unit will open. If the indicator
ashes red your combination is incorrect and you will
need to try again. If you have forgotten or lost your
combination please follow the instructions in section
labeled "Programming Digital Keypad", your backup
key will be required.
05
Safety Feature Section Digital Unit Only
Step 6: Enter your new access code a second time. During
this step the red indicator light will remain illuminated.
Step 7: Press and hold the Learn button a third time.
The indicator light will ash green and beep six times,
this will conrm that the new code has been accepted.
If the indicator light illuminates in red and beeps six
times, an error has occurred and you will need to repeat
steps 3-7.
Step 8: Test your combination to conrm your new
access code.
Step 9: Now you are ready to use your safe.
Step 1: Select a location to mount the unit.
Step 2: Secure the Mounting Bracket to desired
location by fastening the wood screws through the
wall mounting holes.
Step 3 : After securing the Mounting Bracket, remove
the two thumbscrews located on the bottom of the
closed unit.
Step 4 : Unlock the unit with the backup key and
remove the drop down compartment from the shell
of the unit.
Step 5: Secure and fasten the shell of the unit to the
Mounting Bracket by using the 3 woodscrews
provided.
Step 6: Reinstall the removed drop down compart-
ment to the shell and restore the small bottom bracket
with the thumbscrews.
Step 7: Your unit is now installed.
Step 2 : Replace battery by using steps in section labe-
led “Battery Installation”.
*You must open your unit in order for the low battery
indicator to alert you.