MSDS

MSDS - Material Safety Data Sheet
Friday, April 12, 2013
Page 2 of 5
Product Name: PARTS WASHER SOLVENT
MSDS No.: SCS5
Eye Contact: Flush eyes with clean water for 15 minutes while lifting eyelids. Get prompt medical attention.
Skin Contact: Wash with soap and water thoroughly. If adverse effects persist, get prompt medical attention. Launder contaminated clothing
before reuse.
Inhalation: Remove to fresh air. If breathing becomes difficult get prompt medical attention.
Ingestion: DO NOT INDUCE VOMITING! Call Poison Control Center, physician, or hospital emergency room immediately. Aspiration of vomitus
into the lungs can cause pneumonitis, which can be fatal.
Emergency and First Aid Procedures:
IV. First Aid Measures:
Note to Physicians:
N/E
Water Fog, Foam, Carbon Dioxide, Dry Chemical
Suitable Extinguishing Media:
V. Fire Fighting Measures:
Do not use forced water stream as this could cause the fire to spread.
Unsuitable Extinguishing Media:
High temperatures and ignition sources produce products of combustion: carbon monoxide, carbon dioxide & sulfur-like smoke.
Products of Combustion:
Protection of Firefighters:
Wear self-contained positive pressure breathing apparatus and protective clothes.
Persons not wearing protective equipment should be excluded from area of spill until clean-up has been completed.
Personal Precautions:
VI. Accidental Release Measures:
Prevent run-off to sewers, streams, or other bodies of water. If run-off occurs, notify proper authorities as required that a spill has occurred. Run
off to sewer may create fire or explosion hazard.
Environmental Precautions:
Dike or contain spill and absorb with inert materials (sand, sawdust, absorbent sweeping compounds, rags, etc).
Methods for Containment:
Using a non-metalic scoop, place contaminated material into an approved chemical waste container. Where possible, vacuum spilled liquid using
an explosion proof vacuum to recover material.
Methods for Cleanup:
Other Information:
Eliminate all ignition sources. Persons not wearing protective equipment should be excluded from area of spill until clean-up has been completed.
Dike or contain spill and absorb with inert materials (sand, sawdust, absorbent sweeping compounds, rags, etc). Using a non-metalic scoop, place
contaminated material into an approved chemical waste container. Where possible, vacuum spilled liquid using an explosion proof vacuum to
recover material. Prevent run-off to sewers, streams, or other bodies of water. If run-off occurs, notify proper authorities as required that a spill has
occured.
Handling: Use with adequate ventilation and proper protective equipment.
Do not use near fire, sparks, or flame. Store in cool, well ventilated area below 120°F away from heat sources and oxidizers.
Handling Precautions:
VII. Handling and Storage:
Storage Precautions:
Avoid contact with eyes. Avoid prolonged or repeated breathing of vapors. If exposure may or does exceed occupational exposure limits, use a
NIOSH approved respirator to prevent over-exposure.
VIII. Exposure Controls/Personal Protection: