User's Manual

Z
HISHENDO
CCENTER
11
zhiyun-tech.com
12
zhiyun-tech.com
Installing Camera
Installation
Connecting Camera Control Cable
Installation
1.Loosen the mounting plate thumb screw, press and hold the safety lock while sliding out
the quick release plate (to the opposite direction of the arrow mark on it).
2.Install the camera to the quick release plate following the direction of the arrow mark,
then tighten the 1/4" screw at the bottom.
3.Slide in the quick release plate installed with the camera following the direction of the
arrow mark on camera mounting plate, then tighten the thumb screw to finish the
installation of the quick release plate.
4.Loosen the screw on lens support and adjust the support to keep the lens firm and
stabilized.
Do not power on the stabilizer before finishing the camera installation; Please hold the
camera with one hand when powering on the stabilizer in case of malfunctioned rotation.
In the case of Canon camera, connect the control cable to
the port on the tilt motor axis with the Micro USB end, and
then the other end to the left-side port on the camera.
Please make sure the stabilizer is powered off or in standby
mode when connecting the camera control cable in case of
malfunctioned rotation.
Camera brand
Camera model
Camera control
cable model
Camera control
cable interface
Photo
Video
Real-time preview
AV
TV
ISO
Zoom
Focus
EV
Camera charging
Standard camera
control cable
Canon
Sony
Panasonic
5D2/5D3
Sony camera with
MULTI interface
GH3/GH4
ZW-Mini-002 ZW-Micro-002
ZW-MULTI-001 ZW-MULTI-002
Micro USB to Mini USB
Micro USB to Micro USB
Micro USB to MULTI USB
Micro USB to CTIA
√
√
√
√
√
√
×
√
√
×
√
√
√
√
√
√
√
×
√
√
×
√
√
×
×
×
×
×
√
×
×
×
×
√
×
×
×
×
×
√
×
×
√
√
×
×
×
×
×
×
×
×
Zhiyun Camera Control Cable Function Table
√
√ √
5D4
ZW-CTIA-002