User's Manual

Table Of Contents

HISHENDO

CCENTER

Installation

zhiyun-tech.com

Charging Procedure

Tripod

Battery Installation

Please use and charge batteries provided or approved by ZHIYUN only, in case of accidents.

Preparing and Charging the Batteries

1.Insert the batteries into the charger in the right direction (positive/negative end) accordingly.

2.Connect the charger to the adapter via the Micro USB cable.

3.Plug the adapter into the power outlet to start charging.

Micro USB Cable Adapter

Power Outlet

Micro USB Cable Adapter

Power Outlet

There is a Micro USB 5V power input port on both sides of the charger, which supports one

adapter or two adapters charging simultaneously (faster).

2. The simultaneous charging with two adapters may fail when the power is under charged

(like when the current of adapter is below 1000mA); Adapter with higher current capacity is

recommended;

3. The USB Port along side the stabilizer does not support charging to batteries.

1.Please use qualified standard 5V/≥2000mA adapter for battery charging; Charging time

depends on the maximum input current of the adapter.

2.The stabilizer comes standard with three high-discharge-rate dedicated batteries.

Please use and charge batteries provided or approved by ZHIYUN only.

3.Please make sure all three batteries are fully charged. Either under charged battery can

lead to the failure of the stabilizer.

Unscrew the battery compartment and insert the three IMR 18650 batteries in the right

direction (positive/negative end), then tighten the battery compartment.

Get the tripod ready and tighten it to the 1/4"-3/8" threaded hole at the bottom of the

stabilizer, then unfold the tripod on a flat surface.