User's Manual

Z
HISHENDO
CCENTER
Please ensure balanced installation of the camera under top down mode and do not rotate
or shake the handle while initiating the bottom up mode (as seen in graph).
Note: The size of the camera and its balance condition when mounted may affect the
successful access to Bottom Up mode. For certain camera models, balance should be
adjusted after access to Bottom Up mode.
Bottom up Mode Operation
22
21
zhiyun-tech.com zhiyun-tech.com
DC 8.0 V Power Outlet Usage
The DC 8.0 V power outlet on the side of the
stabilizer can be used for charging the Canon
5D camera through a DC connector DR-E6 (
purchase separately).
Charging 5D3/5D4 camera:
Powering on:
1.First, connect the power input end of the
connector to the DC 8.0V power outlet, then
connect the other end of the connector to the
camera.
2.Install the camera to the stabilizer and
power on the stabilizer, then start up the
camera.
Powering off:
First, power off the camera, then unplug the
connector from the stabilizer.
Charging 5D2 camera:
Powering on:
1.Start up the stabilizer, long press the mode
button to enter standby mode.
2. Co nnect the po wer in put en d of the
connector to the DC 8.0V power outlet, then
connect the other end of the connector to the
camera.
3. Install the camera to the stabilizer and
adjust gimbal balance.
4. Power on the camera and long press mode
button to activate the stabilizer.
Powering off:
First, power off the camera, then unplug the
connector from the stabilizer.
Top Down Mode Bottom Up Mode
How to Use
How to Use
1.Original Ca non DR -E6 DC powe r conn ector is
recommended; Please follow the procedure herein in
case of accidents.
2.Please power on/off the camera in accordance with
the procedure, otherwise the camera may fail to star t.