Instruction Manual

Customer Helpline 0333 3201989

NOTE: NOTE: Before using the tool, read the instruction book carefully.

Intended Use

This tool is intended for impact drilling in brick, concrete and stone as well as for

drilling in wood, metal and plastic.

1. AUXILIARY HANDLE (SEE FIG A1, A2)

Slide the handle onto the drill and rotate to the desired working position. Make sure that

the teeth on the grip ﬁt in the protrusions on the handle collar.To clamp the auxiliary

handle, rotate the handgrip clockwise. To loosen the auxiliary handle, rotate the hand

grip anti-clockwise. Always use the auxiliary handle.

WARNING! Always check and rotate the handle tightly before using to avoid any

accident.

2.INSTALLING THE DEPTH GAUGE(SEE FIG B)

The depth gauge can be used to set a constant depth to drill. To use the depth gauge,

loosen the handle by rotating the bottom section of handle anti-clockwise. Insert the

depth gauge through hole in handle. Slide the depth gauge to required depth and tighten

fully.

3. INSERTING A DRILL BIT INTO THE CHUCK (SEE FIG C)

WARNING! Remove the plug from the socket before carrying out any

adjustment, servicing or maintenance.

To open the chuck jaws rotate the front section of the chuck while holding the rear

section. Insert the drill bit between the chuck jaws and rotate the front section in the

opposite direction while holding the rear section. Ensure that the drill bit is in the center

of the chuck jaws. Finally, ﬁrmly rotate the two separate chuck sections in opposite

directions. Your drill bit is now locked in the chuck.

Operating Instructions

A1 A2