User's Guide

Safety and Compliance User Notices

This GPR-device is certified according to FCC, subpart 15, IC RSS-220 and ETSI EN 302

066-1&2.

You are cautioned that changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures: —Reorient or relocate the

receiving antenna. —Increase the separation between the equipment and receiver. —

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected. —Consult the dealer or an experienced radio/TV technician for

help.

According to the regulations stated in ETSI EN 302 066-1 (European

Telecommunication Standards Institute):

The control unit should not be left ON when leaving the system unattended. It should always

be turned OFF when not in use.

The antennas should point towards the ground, walls etc. during measurement and not

towards the air.

The antennas should be kept in close proximity to the media under investigation.

Canadian and US regulations state that whenever GPR antennas are in

use the following notes apply:

This Ground Penetrating Radar device shall be operated only when in contact with or within 1

m of the ground.

Only law enforcement agencies, scientific research institutes, commercial mining companies,

construction companies and emergency rescue or firefighting organizations shall use this

Ground Penetrating Radar Device.

This device complies with Industry Canada license-exempt RSS standards. Operation is subject

to the following two conditions: (1) This device may not cause interference and (2) this device

must accept any interference, including interference that may cause undesired operation of the

device.