Operator's Guide

l
12
Rechargable Artemis Validator
Switch the unit off when not in use to preserve the battery.
!
The Artemis Validator is water resistant.
However, do not submerge the unit in water.
To Switch the Artemis Validator ON:
Press the ON/OFF button on the back of the unit.
Charging
The rechargeable Artemis Validator should be fully charged before
use. A full charge takes approximately 24 hours.
!
DO NOT charge or use the Artemis Validator in an
explosive atmosphere or other hazardous environment.
The Artemis Validator will switch on whilst charging. It cannot be
turned off while charging.
To Charge the Artemis Validator:
!
Note: Only use the supplied charger. Only charge at
ambient temperatures of 0°C to +45°C.
1. Switch off the Artemis Validator and remove the plate on the
rear of the unit.
2. Connect the supplied mains charger (Part No. 21-0464; Input:
100–240VAC, 50–60Hz, 1.5A Output: 24VDC, 2.5A, 60W).
3. When charging is complete, disconnect the power from the unit
and place the rear plate back on.
!
Do not open the Artemis Validator.
If you experience any problems with the unit, please contact:
Guidance Marine Ltd
5 Tiber Way
Meridian Business Park
Leicester Tel: [phone]
LE19 1QP
United Kingdom Email: [e-mail]