Installation Manual

Console and DP Feed connections
Console Connection
You will require a shielded Ethernet cable, remove one of the screw heads from the M20 glands
mounted on the hatch and feed the Ethernet cable through it.
You will see a metal box in front of you with the LED display mounted on it, the Console Ethernet
connector is located on the right hand side of this metal. Each connection is labeled
appropriately.
DP Feed Connection
The Radascan system has two types of connection which will allows you to connect to your DP
feed system. The DP Feed type is output through an Ethernet connector, this can be found on the
right hand side of metal box with the LED display mounted on it. And secondly a D type (9 pin)
connector with the following pin references:
Pin Connection
1 TX-
3 TX+
5 Signal Ground
The D Type connector can be found above the Console Ethernet connector.
Make sure that the shield of the cable is mechanically clamped to the D-Type metal housing. Plug
DP feed cable in to 9 way socket on the side of the breakout housing.
Radascan
Installer – 8