User's Manual

Table Of Contents

Introduction

Welcome to the Artemis Mk6 Installer’s Guide. It explains how to install the Artemis

control software onto a Type 3 Marine Processor or other type of computer, and how

to use it to conﬁgure the Artemis system.

For instructions on how to use Artemis, please see the Artemis Mk6 Operator’s Guide

(Doc No. 94-0440-4).

The

System Overview on page 6 provides an introduction to the Artemis system.

The System Layout section on page 8 describes possible arrangements of the

system on board a vessel. Installing the Sensors on page 12 takes you through the

installation of the Mobile Station, Fixed Station and Beacon, as appropriate.

The

Installing the Control PC section on page 27 gives information for mounting a

Marine Processor supplied by Guidance Marine and how to upgrade the Artemis

control software, if required.

The

Conﬁguring the Artemis System section on page 30 explains how to conﬁgure the

system for your vessel.

FCC ID: VYMARTEMIS

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS

SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT

CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY

INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE

UNDESIRED OPERATION.

NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR

MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR

COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO

OPERATE THE EQUIPMENT.