User's Manual

Configuring the Artemis System
This section explains how to use the Service Interface program to set up the Artemis system.
It contains the following pages:
•
Using the Artemis Service Interface (page 31)
•
Operational Overview (page 32)
•
Adding and Selecting a Remote Station (page 33)
•
Changing the Network Configuration (page 34)
•
Configuring the DP Output (page 35)
•
Configuring System Parameters (page 36)
•
Information Tabs (page 37)
The Service Interface is usually connected to the mobile station of an Artemis system, but it can
also be connected to a fixed station or beacon. We will therefore use the term “local station” to
refer to the antenna unit to which the Service Interface is connected and “Remote Station” to refer
to the other unit, without implying which is mobile and which is fixed.
30