User's Manual

Installing a Beacon (Continued)
Setting Beacon Parameters with the Operating Panel
The setting of the following station parameters is described:
•
Station type
•
Frequency pair
•
Selective address code
•
Auto recovery
•
Configuration protection
•
IP address
The quickest way to set these parameters is by going through the configuration procedure.
1. Switch on the 230 VAC power to the antenna unit.
Note: The ON/OFF switch of the operating panel is not functioning!
2. Wait about 60 seconds for the station to start up.
3. Press Menu; the MAIN MENU MOB, MAIN MENU FIX or MAIN MENU BCN appears.
4. Press 5 (CONFIG). The following page appears:
If the second line reads MOB or FIX:
5. Press Enter; the cursor (<) starts blinking.
6. Press the ▲or ▼key until it reads BCN.
7. Press Enter to acknowledge.
8. Press Next; the following page appears:
Where *:**** **** can have the following values:
If the frequency pair showing is not the desired frequency pair:
9. Press Enter; the cursor (<) starts blinking.
10. Press the ▲or ▼key until the desired frequency pair shows.
11. Press Enter to acknowledge.
12. Press Next; the following page appears:
13. Press Enter; the cursor (<) starts blinking.
14. Using the numerical keys 0-9, enter the desired address code (0-63), i.e. the same address
code configured for the Mobile Station.
15. Press Enter to set the address code.
16. Press Next; the following page appears:
17. If AUTO RECOVERY (default ON) is to be set to OFF (not recommended): press Enter, press
the ▼key to change ON to OFF and press Enter to confirm.
18. Press the ▼key; the cursor points at the parameter CONF.PRTCTED (configuration
protection).
19. Press Enter if the change of settings by the counter station is allowed, then press the ▼key
to change ON to OFF and press Enter again to confirm.
20. Press Next; the following page appears:
25