User's Manual

Installing a Fixed Station (Continued)
Setting Station Parameters with the Operating Panel
•
Station type
•
Frequency pair
•
Selective address code
•
Physical end limits antenna
•
Auto search scan limits antenna
•
Reference azimuth
•
Auto search
•
Anti-icing
•
Auto recovery
•
Configuration protection
•
Gyro compensation
•
IP address
The quickest way to set these parameters is by going through the configuration procedure.
1. Switch the station on by switching the 230 VAC power to the antenna unit on.
Note: The ON/OFF switch on the operating panel is not functioning!
2. Wait about 60 seconds for the station to start up.
3. Press Menu; the MAIN MENU MOB, MAIN MENU FIX or MAIN MENU BCN appears.
4. Press 5 (CONFIG). The following page appears:
If the second line reads MOB or BCN:
5. Press Enter; the cursor (<) starts blinking.
6. Press the ▲ or ▼ key until it reads FIX.
7. Press Enter to acknowledge.
8. Press Next; the following page appears:
Where *:**** **** can have the following values:
If the frequency pair showing is not the desired frequency pair:
9. Press Enter; the cursor (<) starts blinking.
10. Press the ▲ or ▼ key until the desired frequency pair shows.
11. Press Enter to acknowledge.
12. Press Next; the following page appears:
13. Press Enter; the cursor (<) starts blinking.
14. Using the numerical keys 0-9, enter the desired address code (0-63), i.e. the same address
code the Mobile Station is set for and press Enter to confirm.
15. Press Next; the following page appears:
Note: If the antenna can rotate by 360°, this step can be skipped by pressing Next.
21