Operation Manual

Every effort is made to improve our products continuously. Therefore, technical data and figures are

subject to change

Unit 94705 / 94707

This machine is a domestic portable electro-hydraulic drive wood cleaving machine to be used on a working desk.

The machine components are shown in Figure 1.

Fig. 1

A Stock guiding support

B Sliding bench

C Control lever

D Wheels and carriage

E Oil pump

F Motor drive button

G Motor

H Supporting foot

IBase

J Cleaving knife

Introduction

Our wood cleaving machines have been designed and built in conformity with the latest European safety

standards, particularly with EN 609. The operator shall be obliged to instruct the personnel efficiently. The

manufacturer shall not be held liable for any personal or material losses incurred in result of non-observance of

instructions contained herein, unqualified use of the machine, removal of factory and instruction plates, removal or

replacement of protection and safety regulations and otherwise hazardous acts. Alterations of the machine should

be done by authorised personnel only. The instruction manual should be considered an integral part of the

machine and should be kept handy for reference.

Warranty

Warranty claims as per the warranty certificate attached.

General Safety Instructions

Prior to the initial use of the unit, the operating instructions should be read completely. If in doubt with regard

to connection and operation of the unit, consult the manufacturer (servicing department).

Read this manual carefully before putting the unit in

operation.

A.V. 1 Reissues, even if partial, should be authorised. Technical changes reserved.