Operation Manual

8 Inspections and Maintenance

Unplug the unit before any work on it.

• Use a wet cloth to clean the plastic parts. Do not use detergents, solvents or pointed tools.

• Wipe any dirt from the table surface, use a treatment spray.

• If the motor breaking time is above 10 s, the brake wearable parts should be exchanged by the

manufacturer or an authorised shop.

• Prior to every use, remove the dust from the vents and movable parts. Use a soft brush.

• Oil all the movable metal parts regularly.

8.1 Saw Blade Replacement

Fig. 15

• Unplug.

• Remove the table backup.

• Using the hand wheel, take the

saw blade upwards.

• Turn the saw unit at 45°.

•

Wear gloves when replacing the

blade.

• Loosen the socket screw on the

saw case, loosen the lock screw

and remove the saw case plate

• Hold the blade with an socket

wrench and loosen the screw

on it – anticlockwise threading.

• Take out the blade carefully.

• Before installing a new blade,

clean the blade hold with a cloth

or a brush.

Mind the rotation correct

direction when putting the

blade in place. The blade teeth

should point in the direction of

the unit front edge and the

direction of arrow on the blade

and the protection should

coincide.

• Retighten the screws and

reinstall the table backup and

the blade protection.