Operation Manual

GB
15
6.6 Mitre Cut
Fig. 13
• Set the combination stop (Fig.
2/Pos.2) at the required angle.
• Match the piece to be worked
and press to the stop firmly.
• Switch the unit on and draw the
blade carefully through the
piece to the end of the splitting
wedge.
6.7 Rips
Fig. 14
• Set combination stop (Fig.
2/Pos. 2) at the required
distance from the blade.
• Lay the piece to be worked on
the surface of seating; the
flat/wider side should lay flat on
the saw table surface.
• Wide pieces feed by hand on
the blade, left and right.
Notice: Keep safe at a distance
from the blade.
6.8 Lower Draw Feature
Fig. 15
• Combination stop (Fig. 2/ Pos.
2) set at the required width.
• Check to see that the length of
cutting is sufficient.
• Put the piece before the stop.
• Switch the machine on.
Release the draw-enabling lever
(Fig. 2/ Pos.20) and pull the blade
draw slide to cut the piece.
•
6.9 Sawdust Exhaust
Fig. 15
• If the unit is used indoors, a
sawdust exhaust device has to
be connected.
E.g.
Güde GAA 1000 exhaust device
# 55157