Operation Manual

GB
13
6 Operation
6.1 Slant Limitation
Fig. 7
• Blade setting 0° - 45° may be
done on the scale (Fig. 2/Pos.
19). The setting may be altered
by turning the handle (Fig.
2/Pos. 6).
Fig. 8
• The angle of inclination may be
widened in either direction. The
angle setting may be widened
from –
1.5° to 46.5°. by pressing
the angle delimiter (Fig.
2(/Pos. 11 a 5)
6.2 Stop Setting
Fig. 9
• Put the stop rule on the
combination stop (the screws
should run in the guide).
• To fix the combination stop in
place, press the lever (Fig.
2/Pos. 4 + 5) down. To release
it, pull the lever up again.
• To set up an angle, loosen the
screw and push the angle in the
required position.
6.3 Cutting Depth Setting
Fig. 10
• The cutting depth may be set up
by turning the handwheel. (Fig.
2/Pos. 7)
• Turning the wheel to the left =
smaller cutting depth
• Turning the wheel to the right =
larger cutting depth.