Operation Manual

• Use only blades in perfect condition, i.e. sharpened, without cracks, splits, deformations etc. Defective

blades should be replaced immediately.

• See to the arrow on the blade to point the same direction as that on the unit.

• Never remove or disable the unit protection devices.

• Damaged or defective protective devices should be replaced immediately.

• If you are disturb when working with the saw, always complete the step your are doing and look in

another direction only after that.

• The piece you are working should always be on the table of the unit. Never use the unit in a way that

would make the piece being worked occur out of the table.

• Be careful to have your hands placed safely at any time, so that they cannot slip suddenly and get in

touch with the saw.

• Use additional supports or padding if you work with a long piece, for the saw not to get stuck.

• If you work round pieces of wood use a holder preventing the piece from turning on the table.

• The part to be worked shall be unconditionally free of any nails and similar foreign matters. Always

stand on the side of blade when working.

• Do not overload the machine, otherwise it would run slower and will tend to get overheated.

• Never cut several pieces at a time.

• If you cut particularly small pieces, use the sliding device included in the delivery.

• Do not attempt removing loose chips or pieces of wood or a piece that got jammed without switching

off and unplugging the saw.

• To remove defects or the pieces worked, always switch the machine off and unplug first

• Adjustment, measurement, cleaning etc. may be done only after the machine was switched off and

unplugged.

• Do not leave the working area unattended without switching off and unplugging the machine.

• If safety or protective devices are maintained or repaired, they have to be properly reinstalled

immediately after the work is completed. .

• It is unconditional that safety regulations effective in the given place of use are general knowledge

together with the other commonly recognised safety regulations.

• In closed rooms, the machine may be used connected with a matching exhaust system.

• This table circular saw shall be connected to the mains 230 V, 10 A min...

• This machine supply cable should be used for the assigned purpose only. .

• Always pay attention to standing firmly and keeping balance while working.

• Before using the machine, it is unconditional to check the safety devices. Make sure that all the parts,

apparently only slightly damaged, work properly.

• Check the working condition of all the moving parts. Primarily, pay attention to any damaged and stuck

parts. Any parts should be installed correctly and meet all the conditions of perfect functioning.

• Unless otherwise stated in this manual, an authorised servicing centre should repair/replace the

damaged parts and safety devices

• This machine meets any respective safety provisions. Only qualified electricians at authorised servicing

centres are allowed to do repairs, using original spare parts. Non-observance will give a rise to the risk

of accidents.

• Grooves, kerfs etc. should not be made with this machine except for use with required protection

device (fully enclosed).

• The saw should not be used for impact works (such as spliced kerfs).