Operation Manual

Structural Group 3

Required structural groups

Delivered parts and

accessories

Fig. 5

Structural group 2

Fig. 1 – Pos. 1

Fig. 1 – Pos. 13/8 x

Structural Group 4

Required structural groups

Delivered parts and

accessories

Fig. 6

Structural group 3

Fig. 1 – Pos. 3

Fig. 1 – Pos. 2

Fig. 1 – Pos. 6/2 x

Fig. 1 – Pos. 4

Fig. 1 – Pos. 5

5.1 Initial Operation Safety Instructions

• Unplug the machine before adjusting or maintaining it.

• Caution! Rotating blade may injure hands and fingers

• Before the initial operation, check that the electrical data on the plate correspond to those of the mains.

• If you use an extension cable, make sure that the wire for given in out is sufficient. Minimum diameter

1.0 mm2.

• Keep the table and the entire workplace clean. Clear the sawdust and unnecessary tools away.

• Around the saw, mind the places of stumbling risk. .

• If possible, the operator of the machine should not be distracted.

• Pay attention to the motor and blade rotations direction.

• Never brake the blade by a lateral pressure after the motor is switched off.