Operation Manual

30
GSF 300 - 4 PS
GB
Failure removal
Defect
Causes
Measure
Engine not starting or stopping
after a short while
Too low level of the engine oil
Lack of oil protection has been
activated
Check the oil level
Add engine oil
5
Fuel tap closed Open the fuel tap
Petrol tank empty Add petrol
Spark plug dirty from oil or
defective
Clean or replace the spark plug
Wrong gas lever position Correct the settings
Engine not running smoothly
Spark plug dirty Clean the spark plug
Air lter dirty Clean or replace the air lter
17
No drive or drive slipping
Clutch slipping Adjust the cable
Consult with the customer service
centre
No or only minimum snow
ejection
Ejection chimney blocked Switch the engine o and clean the
ejection chimney
Milling worm not rotating as the
clutch is slipping
Adjust the cable
Machine getting stuck on small
unevenness.
Skid set too low Correct the settings
8
Some snow remaining untreated
on the ground
Skid set too high Correct the settings
8
Snow being thrown backwards
behind the machine
Skid set too high Correct the settings
8
Plough worn out Replace the plough
Unsteady running, strong
vibrations
Components and screwed connec-
tion loosened
Switch the engine o and check /
tighten the screwed connection
Replace any damaged parts
Consult with the customer service
centre
ENGLISH
Güde_GSF_300_1.0.indd 30 06.07.12 10:41