Operation Manual

D
22
GB
ENGLISH
Read and understand the operating
instructions before using the
appliance. Familiarise with the
control elements and how to use the appliance
properly. Abide by all the safety measures stated in
the service manual. Act responsibly toward third
parties.
The operator is responsible for accidents or risks to
third parties.
Persons over 16 years of age can only workon the
appliance.An exception includes youngsters trained
in order to reachknowledge under supervision
of the trainer duringoccupational education.
In case of any doubts about connection and operati
-
on refer please to our customer center
Specied Conditions Of Use
GMK 350 TA: The metal chop saw is solely intended
for the dry cutting of pipes, proles, at and round
materials made of steel, aluminium and other non-
ferrous metals using a metal circular saw blade.
WARNING! Do not use cutting discs.
GMT 355: The metal chop saw is solely intended for
the dry cutting of pipes, proles, at and round mate
-
rials made of ferrous metals and stainless steel using a
metal circular saw blade.
Technical Data
Metal Cutting Chop Saw GMK 350 TA GMT 355
Art. No 40549 40534
Service connection 230 V~50Hz 230 V~50Hz
Rated input 2300 W 2200 W
No-load speed 1300 min
-1
3900 min
-1
Saw blade dia. x hole dia 350 x 25,4 mm 72 Z 355 x 25,4 mm 72 Z
Cutting performance Rectangle 45° / 90° 120 x 90 mm /180 x 80 mm 70 x 160 mm/97 x 85 mm
Cutting performance Square 45° / 90° 90 x 90 mm /120 x 120 mm 100 x 100 mm/90 x 90 mm
Cutting performance Round material 45° / 90° 90 mm /120 mm 100 mm /90 mm
Min. workpiece dimensions 10 x 10 x 90 mm 6 x 6 x 120 mm
Weight 14,6 kg 16 kg
Noise details
Sound pressure level L
pA
97 dB (A) 90 dB (A)
Sound power level L
WA
110 dB (A) 103 dB (A)
Measured according to EN 61029 Uncertainty K = 3 dB (A)
Wear ear protectors!
The numerical values given are emission levels and not necessarily safe working levels. Although there is a
correlation between the emission levels and the acceptable exposure levels, they cannot be reliably used to
determine whether or not any additional safety measures are necessary. The characteristics of the work space,
other sources of noise, i.e. the number of machines and other processes running in the vicinity and so on, are all
factors that can inuence the actual exposure levels of the employees. Moreover, the acceptable exposure levels
can vary from country to country. This information should enable the machine‘s operator to carry out a better
assessment of the risks and hazards.
WARNING! Do not use saw blades.
The shape of workpieces must be designed in a way
to provide safe clamping in the machine vice and to
prevent workpiece jump o during cutting.
Do not use this product in any other way as stated
for normal use. Not observing general regulations
in force and instructions from this manual does not
make the manufacturer liable for damages.
Residual risks
Even when the device is used properly and all safety
regulations are complied with, there still may be
some residual risks.
• noise emissions
• dust emissions
• vibrations to hand and arms
• Danger of burns
Tool and workpiece heat up during operation.
• Risk of injury
Sharp tools and workpiece edges