Operation Manual

27
ENGLISH
GB
Inspection and maintenance plan
Regular servicing period Before any
start-up
If necessary Once a
week
After 6
months
Check that the planing blade is in perfect
condition
Inspection

Change
 
Check the function of the safety equipment
Inspection

Change

Clean dust and chips o the machine
Clean

Check the drive belt to ensure it has the
correct tension and is in good condition or
not worn
Inspection

Change
Oil or grease all moving connecting parts
 
Failure removal
Before rectifying a fault on the machine, switch o the machine and pull out the mains plug.
Failures
Causes
Removal
Machine does not work
or stops suddenly
• Power cut
• Motor or switch defective
• Check fuse, check overload switch on
machine.
• Have the motor or switch checked by
an electrician.
Machine stops during
planing
• Planing blade blunt/worn
• Overload switch has tripped
• Replace or sharpen blade
• Switch on the motor again once it has
cooled
Workpiece jams during
thicknessing
• Cutting depth too great • Reduce cutting depth and machine
the workpiece in several passes
Unsatisfactory surface
nish
• Planing blade blunt/worn
• Planing blade lled with chips
• Uneven feed
• Replace or sharpen blade
• Remove chips
• Feed the workpiece with constant
pressure and at reduced speed
Machined surface too
rough
• Workpiece contains too much
moisture
• Dry workpiece
Machined surface cracked • Workpiece was machined against the
grain
• Too much material planed at one pass
• Machine the workpiece from the
opposite direction
• Machine the workpiece in several
passes
Workpiece speed too low
during thicknessing
• Workpiece was machined against the
grain
• Too much material planed at one pass
• Clean bench top and apply a thin
coating of lubricant wax
• Repair transport rollers
• Set the lever for the thicknessing
setting to the top position
Enable and check all safety equipment after all troubleshooting work.