Operation Manual

ENGLISH

Failure removal

Failures Causes Removal

Engine does not start No power in the socket Check the fuse

Defective electric extension cable Pull the plug out, check it, replace it

Wrong connecting cable 5-wire connection at 2.5 mm

cross

section

Defective condenser switch Have the machine checked by a

professional electrician

Wrong engine rotation direction Wrong connection Use a screwdriver to turn the phase-

changing switch in the power supply

Splitting knife is not moving Adjust the two-hand control and

starting levers

Defective control valve - to be

replaced in a service centre only

Splitter has no power

Wrong rotation direction Have the rotation direction changed

by a professional

Few hydraulic oil Hydraulic oil to be added

Trigger is bent; hydraulic piston on

the valve is not fully seated

Check all screws on the trigger

Adjust the trigger so that the

hydraulic piston on the valve is fully

seated

Wood has many knobs and the

splitting knife is getting stuck

Lubricate the splitting knife

Control arm is bent Put the control arm back to the

starting position

The green supply button does not

hold after being pressed

Defective fuse, etc. Check the cable

2-phase running

Hydraulic pump is whistling, split-

ting knife running jerkily

Oil loss, bott

om contamination Tighten the screws replace the hose

Few hydraulic oil Hydraulic oil to be added