User Manual

Expert Power Control NET 24x

19Expert Power Control NET 24x

5. Features

5.2 Firmware update

In order to update the rmware the program GBL_Conf.exe and

the latest rmware are needed.

Activate bootlaoder mode of EPC NET 24x (see 5.1) and run

the program GBL_Conf.exe. On the left side of the program

window all EPC NET 24x that are in the network are listed.

Select the one, that should be updated, click on Program De-

vice→Firmware Update and determine the location of the new

rmware.

To activate the new rmware, you have to disable the bootloader

mode of EPC NET 24x.

5.1 Bootloader mode

To activate the bootloader mode of EPC NET 24x the buttons

“select” and “ok” at the front must be pushed for three seconds.

In bootloader mode it is possible to disable the password protec-

tion, to update the rmware and to restore the default settings by

running the program GBL_Conf.exe.

The bootloader mode of EPC NET 24x is indicated by “BOOT-

LDR” appended to the device name in the program window of

GBL_Conf.exe and by the alternately red and green blinking

status led.

During bootloader mode an alteration of the switching state of a

Power Port is not possible.