User Manual

Expert Power Control 1202/1292

Configuration

Use radius server passwords: Username and password are validated by a Radius

Sever.

Use locally stored passwords: Username and password are stored locally. In this case,

an admin password and a user password must be assigned. The password can have a

maximum of 31 characters. The name "admin" and "user" are provided for the user

name in the password entry mask of the browser. In factory settings, the password for

the admin is set to "admin" or "user" for the user password.

If the password mask is redisplayed, only four "bullets" are shown as a symbolic

placeholder, since for security reasons the device never stores the password itself, but

only the SHA2-256 hash. If you want to change a password, the complete password

must always be re-entered.

If you have forgotten your password, please activate the bootloader mode and

then turn off the password prompt in GBL_Conf.exe.

3.3 Protocols

3.3.1

Console

Enable Telnet: Enables Telnet console .

Telnet TCP port: Telnet sessions are accepted on this port.

Raw mode: The VT100 editing and the IAC protocol are disabled.

Activate echo: The echo setting if not changed by IAC.

Active negotiation: The IAC negotiation is initiated by the server.

Require user login: Username and password are required.

Delay after 3 failed logins: After 3 wrong entries of username or password, the next lo-

gin attempt is delayed.