MSDS

3. COMPOSITION / INFORMATION ON INGREDIENTS
If this section is blank, there are no hazardous components per NOHSC guidelines.
4. FIRST AID MEASURES
General
If symptoms persist, call a physician. Never give anything by mouth to an unconscious person.
Skin:
Take off all contaminated clothing immediately. Wash off immediately with soap and plenty of water. Do NOT use solvents
or thinners.
Eyes:
Remove contact lenses. In the case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
Keep eye wide open while rinsing.
Inhalation:
Move to fresh air. If victim is unconscious but breathing: Victim to lie down in the recovery position, cover and keep him
warm. If not breathing, give artificial respiration. Obtain medical attention.
Ingestion:
Keep at rest. If swallowed, seek medical advice immediately and show this container or label. Do NOT induce vomiting.
5. FIRE FIGHTING MEASURES
Hazchem Code:
None Allocated
Flash point:
205
Lower explosive limit:
not determined
Upper explosive limit:
not determined
Autoignition temperature:
not determined
The following actions are recommended
Collect contaminated fire extinguishing water separately. This must not be discharged into drains.
Fire will produce dense black smoke containing hazardous combustion products (see heading 10).
Wear self contained breathing apparatus for fire fighting if necessary.
Cool containers / tanks with water spray.
Suitable extinguishing media
Suitable extinguishing media
Alcohol-resistant foam
Carbon dioxide (CO2)
Dry powder
Extinguishing media which must not be used for safety reasons
High volume water jet
6. ACCIDENTAL RELEASE MEASURES
Personal precautions:
Exclude non essential personnel. Remove all sources of ignition. Ensure adequate ventilation. Do not breathe
vapours/dust.
Environmental precautions:
Local authorities should be advised if significant spillages cannot be contained.
Methods for cleaning up:
Contain spillage, and then collect with non-combustible absorbent material, (e.g. sand, earth, diatomaceous earth,
vermiculite) and place in container for disposal according to local / national regulations. Soak up with inert absorbent
material (e.g. sand, silica gel, acid binder, universal binder, sawdust). Clean with detergents. Avoid solvents.
7. HANDLING AND STORAGE
Product ID: 470200
Page 2 / 5