MSDS

Inhalation:
Move injured person into fresh air and keep person calm under observation. Get medical attention immediately. For
breathing difficulties, oxygen may be necessary. If breathing stops, provide artificial respiration. Do not give direct mouth-
to-mouth resuscitation if inhaled. To protect rescuer, use air-viva, oxy-viva or one-way mask. Resuscitate in a well-
ventilated area.
Medical conditions aggravated by exposure:
Any respiratory or skin condition.
5. FIRE FIGHTING MEASURES
Flash point (Fahrenheit): -100
Flash point (Celsius): -73
Lower explosive limit (%): 0.7
Upper explosive limit (%): 10
Autoignition temperature: not determined
Sensitivity to impact: no
Sensitivity to static discharge: Subject to static discharge hazards. Please see bonding
and grounding information in Section 7.
Hazardous combustion products: See Section 10.
Unusual fire and explosion hazards:
None known.
Extinguishing media:
Carbon dioxide, dry chemical, foam and/or water fog.
Fire fighting procedures:
Firefighters should be equipped with self-contained breathing apparatus and turn out gear. Keep containers and
surroundings cool with water spray.
6. ACCIDENTAL RELEASE MEASURES
Action to be taken if material is released or spilled:
Ventilate the area. Avoid breathing dust or vapor. Use self-containing breathing apparatus or airmask for large spills in a
confined area. Wipe, scrape or soak up in an inert material and put in a container for disposal. See section 7, "Handling
and Storage", for proper container and storage procedures. Remove all sources of ignition. Soak up with inert absorbent
material. Use only non-sparking tools. Avoid contact with eyes.
7. HANDLING AND STORAGE
Precautions to be taken in handling and storage:
Keep away from heat, sparks and open flame. - No smoking. Keep container closed when not in use. Do not store above
120 degrees F. (49 degrees C). Based on flash point and vapor pressure, suitable storage should be provided in
accordance with OSHA regulation 1910.106, Ontario OH&S regulation 851 section 22. Empty containers may contain
product residue, including flammable or explosive vapors. Do not cut, puncture or weld on or near container. All label
warnings must be observed until the container has been commercially cleaned or reconditioned. If the product is used
near or above the flashpoint, an ignition hazard may be present. Activities, uses, or operations which liberate vapor (such
as mixing or free fall of liquids) may also present an ignition hazard. Please ensure containers and other interconnected
equipment are properly bonded and grounded at all times.
8. PERSONAL PROTECTIVE EQUIPMENT AND EXPOSURE CONTROLS
Personal Protective Equipment
Eye and face protection:
Wear safety glasses or goggles to protect against exposure.
Skin protection:
Product ID: 460900.072
Page 3 / 7