Product Manual

Example:
INCORRECT!!
990 m descend. work change w/out inspect. 7.5m hoisting change w/out inspect. 10m descending inspection
CORRECT!!
990m descend. work change after inspect. 7.5m hoisting change after inspect. 10m descending inspection
The manufacturer’s Inspection Lists for the performance of the service inspection and the relevant Instructions for
Use must be observed.
The performed descending work and the done revision examination must be entered into the attached list for
documentation purposes. You must separate the rope work petween abseiling and hoisting.
NOTE: Authorization for the execution of training courses and excercises
Application training courses may be implemented only by persons who were trained by the manufacturer or
a competent person named by the manufacturer and who have a certificate of the training. Exercises may take
place only under supervision of a person, who participated on application training course by the manufacturer
or a competent person named by the manufacturer and is competend and can verify this by a certificate.
The manufacturer or a direct representative of the manufacturer trains trainers / coaches. The training to the coach
contains at the same time the training to experts. The trained coach is entitled to carry out application training
courses as well as expert training courses. The coach is not entitled to accomplish training courses for coaches.
9. Info sheet for visual inspection of abseiling and abseiling-rescue hoist
Inspection of the device housing
Inspection of the rope entry and exit points
The wear at the rope entry/exit point must be checked. The rope entry/exit point must show a wear greater than 2mm.
The device must be withdrawn from use if the wear is greater.
The material in the wear area has a polished, smooth, bright surface. The wear shows a secere through formation
on the material.
Inspection of the device housing
1. The housing halves must be checked for corrosion, mechanical damage, deformation and cracks.
This check is carried out visually. The device must be with drawn from use and sent to the manufacturer for
inspection if it shows cracks, deformation, corrosion or mechanical damage.
2. Inspection of the cylinder head screws for completeness and tightness.
A visual inspection for the presence of all cylinder head screws must be carried out. The insertion depth of the
screws shows if a screw is loose. Screws found to be loose during the inspection must be tightened with the
corresponding spanner (accessory set). The device must be withdrawn from use if not all the screws are present.
Inspection of the safety carabiner and the shackle
The safety carabiner and the shackle must be visually inspected for corrosion, mechanical damage, deformation
and cracking. The equipment must be withdrawn from use if damage is present. The correct functioning of the
catch of the safety carabiner and the rivet on the safety carabiner must also be checked. The catch of the safety
carabiner must return to its rest position automatically after it has been pressed in by hand. The coupling nut must
allow an easy opening and closing.
AG 10 Hoist A 7