Product Name: Big Boss Lanyard Part #: 21300; 21301; 21302; 21303; 21310 Instruction Manual Do not throw away these instructions! Read and understand these instructions before using equipment! Introduction 1 Applicable Safety Standards 1 Worker Classifications 1 Product Specific Applications 2 Limitations 2-3 Components and Specifications 3 Installation and Use 4 Maintenance, Cleaning, and Storage 5 Inspection 5 Inspection Log 5 Safety Information 6 Labels 7
User Information Trainer: User: Applicable Safety Standards When used according to instruction specifications, this product meets or exceeds all applicable OSHA 1926 Subpart M, OSHA 1910, ANSI Z359.13-2013, and ANSI A10.32-2012 standards for fall protection. Applicable standards and regulations depend on the type of work being done, and also might include state-specific regulations. Consult regulatory agencies for more information on personal fall arrest systems and associated components.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 Guardian Fall Protection Product Specific Applications ! WARNING Use of equipment in unintended applications may result in serious injury or death. Maximum 1 attachment per connection point. Personal Fall Arrest: Big Boss Lanyard may be used to support a MAXIMUM 1 Personal Fall Arrest System (PFAS) for use in Fall Arrest applications.
Two or more snap hooks or carabiners connected to each other. NO. Connector directly to webbing. NO. Two connectors to same D-ring. NO. Application that places load on gate. NO. Incompatible or irregular application, which may increase risk of roll-out. NO. Connector directly to horizontal lifeline. NO. Components and Specifications The specific components of Guardian Big Boss Lanyards vary depending on design and intended application. All webbing is made from Polyester and Nylon, and is 1” in width.
www.guardianfall.com 1. Prior to use, inspect Guardian Big Boss Lanyard and all PFAS equipment to be used in combination with Big Boss Lanyard. 2. Ensure that all connectors and all other components of the PFAS are compatible with Big Boss Lanyard, and are selected by a Competent Person. The selected safety harness MUST be of proper size, and MUST be fitted snugly, but still allow for a full range of movement. 3. Make considerations for eliminating or minimizing swing fall hazards. 4.
When not in use, store equipment where it will not be affected by heat, light, excessive moisture, chemicals, or other degrading elements. Inspection Prior to EACH use, inspect Big Boss Lanyard for deficiencies, including, but not limited to, corrosion, deformation, pits, burrs, rough surfaces, sharp edges, cracking, rust, paint buildup, excessive heating, alteration, and missing or illegible labels.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 Guardian Fall Protection Safety Information ! WARNING Failure to understand and comply with safety regulations may result in serious injury or death. Regulations included herein are not all-inclusive, are for reference only, and are not intended to replace a Competent Person’s judgment or knowledge of federal or state standards. Do not alter equipment. Do not misuse equipment.
www.guardianfall.com WARNING! Compliant with all applicable ANSI Z359.13-13, ANSI A10.32-12, OSHA 1910, and OSHA 1926 Subpart M regulations. Capacity: 130-310 lbs. (including tools) up to 12’ free fall. 311-420 lbs. (including tools) up to 6’ free fall. Max. Elongation: 60” Materials: Polyester, nylon, & galvanized steel or aluminum. DO NOT REMOVE LABELS Follow manufacturer’s instructions provided with this lanyard at time of shipment from manufacturer.
