Product Name: Single Stanchion Part #: 15225 Instruction Manual Do not throw away these instructions! Read and understand these instructions before using equipment! Introduction 1 Applicable Safety Standards 1 Worker Classifications 1 Product Specific Applications 2 Components and Specifications 3 Installation and Use 4 Maintenance, Cleaning, and Storage 5 Inspection 5 Inspection Log 5 Safety Information 6 Labels 7
User Information Date of First Use: Serial #: Trainer: User: Applicable Safety Standards When used according to instruction specifications, this product meets or exceeds all applicable OSHA 1926 Subpart M and OSHA 1910 standards for fall protection. Applicable standards and regulations depend on the type of work being done, and also might include state-specific regulations. Consult regulatory agencies for more information on personal fall arrest systems and associated components.
www.guardianfall.com ! WARNING Use of equipment in unintended applications may result in serious injury or death. Maximum 1 attachment per connection point. Fall Prevention: Single Stanchions may be used in Fall Prevention applications ONLY. Fall Prevention Systems are placed around the leading edges of any and all fall hazards to prevent a worker from going over an edge, and may be used in substitute of Fall Protection or safety netting systems.
Carrying Handle Stanchion Leg Single Stanchion height: 39”. #01400: 3/8” diameter wire rope (not included) #15308: Steel Warning Flag (not included). #15231: Synthetic warning line with flags (not included). 3 www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 Warning Line Connection Point 6305 S. 231st St.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 Prior to installation, plan your system: 1. All equipment to be used in combination with the Single Stanchion must be selected and deemed compatible by a Competent Person. 2. Ensure work surface on which Single Stanchion System is to be installed is free of all damage, including, but not limited to, rot, rust, cracking, sharp or abrasive edges and surfaces, and hazardous materials. 3.
When not in use, store equipment where it will not be affected by heat, light, excessive moisture, chemicals, or other degrading elements. Inspection Prior to EACH use, inspect Single Stanchion for deficiencies, including, but not limited to, corrosion, deformation, pits, burrs, rough surfaces, sharp edges, cracking, rust, paint buildup, excessive heating, alteration, and missing or illegible labels.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 Guardian Fall Protection Safety Information ! WARNING Failure to understand and comply with safety regulations may result in serious injury or death. Regulations included herein are not all-inclusive, are for reference only, and are not intended to replace a Competent Person’s judgment or knowledge of federal or state standards. Do not alter equipment. Do not misuse equipment.
www.guardianfall.com Labels 90197 (Rev. B) Part #: 15225 6305 S. 231st St. Kent, WA 98032 1-800-466-6385 www.guardianfall.com Prior to use, read and understand all manufacturer’s instructions provided with equipment at time of shipment. User must inspect prior to EACH use. Competent Person must complete formal inspection every 6 months. Competent Person to inspect and initial. Date of First Use: _______________.
