Item Brochure

Guardian Fall Protection 6305 S. 231st St., Kent, WA 98032 phone: [phone] fax: [phone] www.guardianfall.com
Single Stanchion
Part #: 15225
Materials: powder-coated steel.
Compliant with all OSHA 1910 and
OSHA 1926 Subpart M regulations.
Single Stanchion is suitable for the following applications:
Custom configurations not available. Not repairable.
Contact customer service for details.
Surfaces more than 6’ above lower levels require the use
of a Fall Prevention or Fall Protection system.
Fall Prevention: Single Stanchion Systems may
be used in Fall Prevention applications ONLY.
Fall Prevention Systems are placed around the
leading edges of any and all fall hazards to
prevent a worker from going over an edge, and
may be used in substitute of Fall Protection or
safety netting systems. Installation requirements for Permanent Warning Line Stanchion
Systems set forth in equipment instructions MUST be adhered to. Personal Fall Arrest,
Work Positioning, Climbing, Rescue, and any other systems must NEVER be connected to
Fall Prevention Systems.
Single Stanchion height: 39”.
Recommended for use with:
• 3/8” diameter Wire Rope (#01400) & Steel Warning Flags (#15038)
• Synthetic Warning Line w/Flags (#15231)
Single Stanchions must be placed a MINIMUM 6’ from the leading edge of all fall hazards.
When mechanical equipment is in use, Single Stanchions must be placed a MINIMUM 6’ from the
leading edge parallel to the direction of the mechanical equipment, and 10’ from the leading edge
perpendicular to the direction of the mechanical equipment.
Single Stanchions may be placed a MAXIMUM 50’ apart.
Warning Line MUST be rigged so lowest point is not below 34” and highest point is not above 39”.
Warning flags MUST be installed on Warning Line no more than 6’ apart.