Tech Sheet

Guardian Fall Protection 6305 S. 231st St., Kent, WA 98032 phone: [phone] fax: [phone] www.guardianfall.com
2-Way Standing
Seam Roof Clamp
For installation onto compatible roof seams ONLY. A Qualified
Person must determine seam compatibility. Please contact
Guardian Fall Protection with any questions regarding roof
seam compatibility.
Materials: galvanized steel.
Compliant with all OSHA 1910, OSHA 1926 Subpart M,
ANSI Z359.1-2007, and ANSI A10.32-2012 regulations.
2-Way Standing Seam Roof Clamp is suitable for the following applications:
MAXIMUM 1 connection per 2-Way Standing Seam Roof Clamp.
UPC-A Code: 672421106007
Custom configurations not available. Not repairable.
Contact customer service for details.
Personal Fall Arrest: 2-Way Standing Seam Roof Clamps may be used to support a
MAXIMUM 1 Personal Fall Arrest System (PFAS) for use in Fall Arrest applications. Structure
must withstand loads applied in the directions permitted by the system of at least
5,000 lbs. Maximum free fall is 6‘, or up to 12’ if used in combination with equipment
explicitly certified for such use. Applicable D-ring: Dorsal.
Restraint: 2-Way Standing Seam Roof Clamps may be used in Restraint applications.
Restraint systems prevent workers from reaching the leading edge of a fall hazard. Always
account for fully deployed length of lanyard/SRL. Structure must withstand loads applied in
the directions permitted by the system of at least 1,000 lbs. No free fall is permitted.
Restraint systems may only be used on surfaces with slopes up to 4/12
(vertical/horizontal). Applicable D-rings: Dorsal, Chest, Side, Shoulder.
For all applications: worker weight capacity range
(including all clothing, tools, and equipment) is 130-420 lbs.
Not for use in a horizontal lifeline system.
Part #: 10600