Use and Care Instructions

E-6 E-7
1. Separate the tank from the
base of the unit.
2. Flipoverwatertankandopenthe
tank lid, turning it to the left.
3. Pour cool, clean water directly
 intothetank.Donotpouranything
but water into the tank.
4. Close the tank lid, turning it to the right.
 ItisimportanttoFIRMLYsecurecapafter
filling the tank with water.
5. Attach the tank to the base of the
unit and plug in.
6. Power Button
 Beforeturningonmakesurethere
is water in the unit. Turn the
Power button.
1. Night Light Feature
Turn Night Lamp dial to illuminate
the night light.
2. Variable Mist Control Dial
Turn the Mist Control dial to select
the amount of mist you prefer.
4. Water Refill Indicator
When the unit is low on water the Refill
 LEDonthefrontpanelwilllightup,and
the unit will shut off. Simply add more
water to continue use. Unit will
automatically resume running when
water tank has been refilled.
5. Humidity Spout Dual Direction
 Broadenmistintwodifferent
directions throughout the room by
rotating top section.
MIST
POWER
WARM
OFF
COOL
LIGHT
NO WATER
SET UP
Selectarm,level,atlocation-atleastsixinches(15cm)fromanywallorobjectforproperair
ow.Placethehumidieronawater-resistantsurface,aswatercandamagefurnitureandsome
ooring.Donotplaceunitdirectlyoncarpet,towels,blanketsorotherabsorbentsurfaces.
Guardian Technologies will not accept responsibility for damage caused by water spillage.
FILLING
Make sure unit is unplugged.
DIRECTIONS FOR USE DIRECTIONS FOR USE
Rotates
separately
CONTROL OPERATION
3. Cool or Warm Humidification Indicator
Select cool or warm mist. Water
temperature is maintained at room
temperature for cool setting and
80 degrees for warm. Allow 15 minutes
for water to warm.
POWER
OFF
COOL
WARM
LIGHT
NO WATER
POWER
OFF
COOL
WARM
LIGHT
NO WATER