Instructions

E-7
Water vapor and humidity
are not produced.
Power Plug: Unplug and then try again.
Power Failure: When the power is returned, try again.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
PROBLEM
SOLUTION
Air blows but water vapor
is not produced.
Excessive Water: Empty the water in the base of the unit.
Detergent residue and/or oil ingredients from cosmetics, eta may be in
tank; wash out tank and try again.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
If you use hard water, replace with softer water.
Humidity level is low.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
The water in the unit is too cold: Replace with cool, but not cold water.
Damage on the ultrasonic disk: Contact Customer Service
The humidity has
a bad smell.
Poor maintenance or dirty water: Clean the product thoroughly,
and fill it with fresh water.
White dust is forming on
nearby furniture.
Hard water may deposit a certain amount of dust. Dust in the air also
settles because of added humidity in the room. Use distilled water if
this becomes a nuisance.
Unit has stopped working.
No or low water. Unplug unit and refill tank.
Water is accumulating
outside of unit or area
surrounding unit.
Saturation of humidity. Lower mist control setting.
Unit not level and water is accumulating. Unplug and place on level
surface. Point spray away from objects. Raise unit on a water-resistant
level surface 2-3 feet off of floor.
Increased noise level.
Unit must be placed on a flat, level, hard surface.
Make sure it is NOT placed on a soft or absorbent surface.
Power button flashing red.
Indicates low water. Unplug and refill tank.
Cannot smell aroma scent.
Add a few more drops of oil to the aroma
pad or replace aroma pad with a new one.
TROUBLE SHOOTING GUIDE