Instruction Manual

E-6 E-7
DIRECTIONS FOR USE
1. Removecapfromstandardsizedwater
 bottle-recommend16oz.(.5L).
SET UP
Selectarm,level,atlocation-atleastsixinches(15cm)fromanywallorobjectforproperair
ow.Placethehumidieronawater-resistantsurface,aswatercandamagefurnitureandsome
ooring.Donotplaceunitdirectlyoncarpet,towels,blanketsorotherabsorbentsurfaces.
Guardian Technologies will not accept responsibility for damage caused by water spillage.
Make sure unit is unplugged.
3. Turn upside down and insert into
bottle into the tank. The bottle will
immediately begin to release
water into the base.
6. Turn the dial to turn power on.
2. Replace with bottle adapter provided.
Turn clockwise tightly to seal.
7. Adjust dial for various mist levels.
8. Nightlightwillautomaticallyturnon/offwiththepower.
9. Unit will automatically turn off if there is no water.
CLEANING
• Always unplug the unit before servicing in any way.
GENERAL CLEANING
• Inside the base of the unit. Pourexcesswateroutoftheunit.Washouttheunitwithfresh
water using the cleaning brush and a soft cloth as needed. Do not submerse the base of the
unit into water, or allow water to enter inside the dry air exhaust port of the unit.
• Outer surface of the unit. Wipe the surface of the unit with a soft, damp cloth if needed. If
you notice an accumulation of water during usage, reduce humidity and dry outer surface with
a cloth.
DESCALING
• Depending on usage and water type, cleaning to remove scale may be required
weekly or every other week to optimize unit performance.
• Do not clean the unit with detergents or cleaning chemicals of any kind.
ULTRASONIC DISK
1. Unplug unit.
2. Empty all water from the unit base.
3.Pullmistnozzleuptoremovethetopcoverofthe
humidifier. Locate the ultrasonic disk on the inside
 ofthebaseunit.(seepg.E-4)
4. Use ONLY the enclosed cleaning brush to gently
clean disk and remove build up and deposits.
Do not scrub or scrape the ultrasonic disk.
If scale becomes difficult to remove with brush:
1.FilltheBasewith:mixtureof1tsp.whitevinegarand1tsp.water.
2. Let solution stand for 5 minutes.
3.WiththevinegarintheBase,cleanallinteriorsurfaceswithasoftclothorbrushtohelp
remove scale.
4.RinsetheBasethoroughlywithwatertoremovescaleandvinegarsolution.
END OF SEASON STORAGE
•FollowtheCleaningandDescalinginstructionswhenthehumidierwillbestoredattheend
of the season.
•Drythehumidiercompletelybeforestoring.DONOTstorewithwaterinsidetheBase.
•Pack the unit in its original carton and store in a cool, dry location.
NOTE: IF YOU EXPERIENCE A PROBLEM DO NOT ATTEMPT TO OPEN THE MOTOR
HOUSING YOURSELF. DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE
TO THE HUMIDIFIER OR PERSONAL INJURY.
CLEANING
*Clean the disk with the
brush only. No other
cleaning tool should
beused.BRUSHONLY.
Ultrasonic Disk
4. Plug the power adapter into the unit
then plug into an outlet.
5. Raisemistnozzletouprightposition.
IMPORTANT: POWER WILL NOT
ACTIVATE WITHOUT RAISED MIST
OUTLET AND WATER.