Manual

E-6 E-7
1. Power Button
Before turning on make sure there is water in the unit.
Press the Power Button.
2. Warm or Cool Mist Button
Press to select warm or cool mist. Water
temperature is maintained at room temperature for cool
setting and 80 degrees for warm.
3. Spray Control Button
When you press the Spray Control Button
there are four options to choose from:
Press once for WEAK
Press twice for MIDDLE
Press three times for STRONG
Press four times for TURBO
*You will notice the lights get higher as the spray increases.
4A. Light Options - Display Button
Press the Display Button to turn the display lights ON or OFF.
5. Water Rell Button
When the Water Rell Button lights up it is time to rell
the water tank.
Program Start
1. Push Select/Set Button until "START" is blinking on display.
2. While "START" is blinking, select the desired start time using Hour and
Minute buttons (AM or PM as indicated).
3. Select Cool/Warm preference.
4. Select Spray Control preference.
5. "START" indicator will remain lit once programmed.
Power
Cool/Warm
S
p
C
Spray
Control
Dim
Display
Lamp
4B. Light Options - Night Light Feature
Press the Lamp Button at the top of the unit to illuminate
the night light feature.
Select/Set
Start
Stop
Time
D
one
set
Hour
r
Minute
Program Stop
1. Push Select/Set Button until "STOP" is blinking on display.
2. While "STOP" is blinking, select the desired end time using Hour and
Minute buttons (AM or PM as indicated).
3. "STOP" indicator will remain lit once programmed.
4. To cancel program, press and hold select/set button for two seconds
(START and STOP buttons will not be lit).
Clock Set
1. Clock must be set in order for timer to work properly.
2. Push Select/Set Button until "TIME" is blinking on display.
3. Select actual time using Hour and Minute Buttons (AM or PM as indicated).
The programmable mode allows you to set the timer to turn the humidier both on/off
at a daily predetermined time. This mode also allows the clock to be programmed.
FIRST TURN POWER BUTTON ON.