User Manual

CLEANING & REPLACING FILTER
TO OPTIMIZE THE VACUUM PERFORMANCE YOU SHOULD CLEAN THE
FILTER EACH TIME YOU EMPTY THE DIRT CUP.
1. Lift up the dirt cup cover, rotate and remove the lter protector.
2. Rotate and remove the inner lter. (Fig. 21)
Tap the inner lter on a trash bin to remove the dust from the pleats. (Fig. 22)
NOTE: This inner lter is washable and can be rinsed if you notice a reduction in
vacuum performance (suction). To wash, rst tap lter to remove excess dirt and
dust from pleats. Rinse lter clean with warm water then allow to completely dry
(a minimum of 24 hours) before returning to dirt cup. Use lter: FLTB for inner dirt cup.
r
Tap Gently
Fig. 21 Fig. 22
EXHAUST FILTER CLEANING & REPLACEMENT
• Pull out the exhaust lter. (Fig. 23)
• Replace the exhaust lter when it becomes dirty. (Fig. 24)
Use lter: FLTA for exhaust lter.
CAUTION: This lter is NOT washable.
Filter
Filter Frame
Body
Exhaust
Filter
Fig. 23
Fig. 24
NOTE: Replacement parts can be purchased by calling
1.866.603.5900 or by visiting www.guardiantechnologies.com.
Dirt Cup Cover
HEPA
Inner Filter
(Located inside
Filter Protector)
Filter Protector
*HEPA Filter is located
INSIDE the green lter
protector. Remove lter
protector to access
HEPA Filter.
*
E-10
E-11
-
Fig. 19
Dirt Cup
Release Button
Fig. 20
Dirt Cup
Release Button
Dirt Cup
Body
CLEANING DIRT CUP
• You will need to empty dirt cup when dust reaches the FULL line.
• Turn OFF the vacuum and unplug from electrical outlet.
• Grasp the dirt cup handle and depress button, pull out the dirt cup from
the body. (Fig. 19)
• To empty, remove the dirt cup and hold over trash bin. Push the dirt release
button and dispose of the dirt. (Fig. 20)