USE & CARE INSTRUCTIONS pureguardianTM 2-in-1 Upright and Canister with Silver Clean Technology English French Spanish E-1 F-1 S-1 Replacement Parts: HEPA Dirt Cup Filter FLTB Exhaust Filter FLTA Belt BLT1 Model No. GGU350TT 1-Year Limited Warranty www.guardiantechnologies.com 1.866.603.5900 REV0411 Date Purchased month ________ year _________ ! WARNING: Cleaner assembly may include small parts. Small parts can present a choking hazard.
This vacuum is intended for household use only This vacuum is intended for household use only Important safety instructions Important safety instructions When you use an appliance, basic precautions should always be followed. Please read the entire manual before using this appliance. • READ ALL INSTRUCTIONS BEFORE USE. • ALWAYS FOLLOW SAFETY INSTRUCTIONS. • BRING VACUUM TO AN UPRIGHT POSITION IF NOT USING IN CANISTER MODE TO USE THE HOSE AND ATTACHMENTS.
Hose Cradle Assembly please read all instructions before using this appliance WARNING! Do not use the Dirt Cup Handle to move the cleaner. THERMAL RESET BUTTON: Operates due to overheating, caused by a full dirt cup, clogged filter or blocked pipes. Unplug the cleaner and remove the blocked materials. To operate again, after cooling down the cleaner about 30 minutes, press the Thermal Reset Button. Model .................................................. GGU350TT Rating .................................
Vacuum Assembly: upright Use (contd) Tool Assembly Handle Assembly Handle Assembly • Insert handle in the handle inlet on the top of the body. (Fig. 6) tool assembly • Attach crevice tool, dusting brush and upholstery brush into storage area on the back of the vacuum. (Fig. 8) Handle Handle Disassembly • Push the handle removal button. • Pull handle upward to remove. Crevice Tool Dusting Brush Fig. 8 Protrustion to Lock Upholstery Brush Handle Inlet Handle Removal Button Fig.
Upright Mode: Tool Usage Storing in Upright mode tool usage 1. Turn brush OFF. 2. Remove hose from base hose connector on the lower portion of the cleaner. (Fig. 12) 3. Remove handle from cleaner: Push handle removal button and pull up on handle to disconnect from body. (Fig. 13) 4. Insert hose into handle hose connector and twist clockwise to lock in position. (Fig. 14) 5. Push button on wand to extend telescoping wand. (Fig. 15) 6.
cleaning & replacing filter Cleaning Dirt Cup • • • • You will need to empty dirt cup when dust reaches the FULL line. Turn OFF the vacuum and unplug from electrical outlet. Grasp the dirt cup handle and depress button, pull out the dirt cup from the body. (Fig. 19) To empty, remove the dirt cup and hold over trash bin. Push the dirt release button and dispose of the dirt. (Fig. 20) To optimize the vacuum performance you should clean the filter each time you empty the dirt cup. 1.
Belt replacement • • • • • WARNING: Before replacing the belt, make sure the cleaner is unplugged from the electrical outlet. Turn OFF the cleaner and unplug from electrical outlet. Remove the bottom plate of the base by removing the five (5) screws using a Phillips screwdriver. (Fig. 25) Set the new belt over motor pulley. (Fig. 26) Use replacement belt: BLT1. Slip the brush roll into the belt and reassemble. (Fig. 27) Replace the bottom plate and secure the 5 screws.
limited warranty To the consumer, Guardian Technologies LLC warrants this product to be free of defects in materials and workmanship commencing upon the date of the original purchase. Save your original sales receipt to validate start of warranty period. If this product should become defective within the warranty period, we will repair or replace any defective parts free of charge. The complete machine must be delivered pre-paid to any authorized Guardian Technologies LLC warranty service center.
