User's Manual

24
Troubleshooting
Problem Possible Cause / Solution
Opener does not close and beeps
The Photo Eye may be obstructed, not properly aligned or installed,
check connection and alignment referring to pages 13 & 16.
Opener does not respond to Remote Control
- Refer page 21 to reprogram Remote Control.
- Check Remote Control battery.
Opener stops before reaching full open / close
position
Travel Limit is not properly adjusted, check adjustment referring to
pages 17-19. Conduct Safety Reverse Test after ANY adjustment.
The door reverses unintentionally
- Make sure the Photo Eye Safety System is aligned and clear of
obstructions.
- If door is replaced or door condition has significant changes,
- Refer to page 4 to check the door balance
- Refer to page 17-19 to re-adjust Travel Limits and Travel Force.
The door reverses upon touching the floor and
the courtesy light flashes
Refer to page 17-19 to reset Travel Limits and Travel Force.
The Opener does not close the door and the
green LED on the Photo Eyes flashes
The Photo Eye Safety System is misaligned or obstructed, refer to
page16 for proper alignment.
The Opener is working properly but the courtesy
light does not turn on
Replace light bulb (A19 incandescent Max.100W).
The courtesy light does not turn off Defective Logic Board.
Schedule Maintenance
Once a month
Door balance test, refer to page 4.
Safety reverse test, refer to page 20.
Twice a year Check chain/belt tension ( refer to page 6 for adjustment if necessary).
Once a year
- Limit and Force adjustment may be necessary due to weather conditions.
Refer to pages 17-19 for adjustment. Conduct Safety Reverse Test after ANY
adjustments.
- Lubricate door rollers, bearings and hinges. The Opener is permanently
lubricated, DO NOT lubricate or grease the Opener, rail or door tracks.
Maintenance
Red Green LED
Green LED
Green LED
Green LED
Red LED
Green LED
Red LED
Red LED
Green LED
Red LED
Red LED
Note: If installing operators on two doors in the same garage, to ensure proper operation, Photo Eyes should
be aligned as below: