User's Manual

21
!
WARNING
To Prevent SERIOUS INJURY or DEATH:
- Keep remote control and battery out of reach of children.
- NEVER permit children to access the Door Control Console, Push Button nor Remote Controls.
- Operate the door ONLY when it is properly adjusted, and there are no obstructions present.
- ALWAYS keep a moving door in sight until completely closed. NEVER cross the path of a moving door.
To reduce risk of fire, explosion or electric shock:
- DO NOT short circuit, recharge, dissemble or heat the battery.
- Replace with 23AE 12 Volt batteries ONLY. Dispose of batteries properly.
Programming Remote Controls * (OPTIONAL)
To Program Remote Control (s):
1. Press/release the “LEARN” button once on the rear control
panel, “OK” LED will glow and beep. The unit is now ready
to accept a remote control in the next 30 seconds as
shown in Fig.2.
2. Press/release any desired button on the Remote Control.
3.
The
“OK”
LED will flash and beep twice indicating
Remote Control is stored successfully.
Up to 20 Remote Controls (including wireless keypad codes)
can be added to the unit by repeating the above procedures.
If more than 20 Remote Controls are stored, the first stored
Remote Control will be replaced. (i.e. the 21st Remote Control
replaces the 1st stored Remote Control .)
Removing ALL Remote Controls:
To remove ALL Remote Controls from memory, press and hold
the “LEARN” button for 5 seconds. The “OK” LED will flash and
beep 2 times indicating. ALL Remote Controls have been re-
moved from memory.
Replacing Remote Control Battery:
Whe
n the battery of the Remote Control is low, the indicator
light will become dim and/or the range of the Remote Control
will decrease. To replace the battery, remove the battery cover
from the Remote Control as shown in Fig 4. Replace with a
23AE 12 volt alkaline battery with polarity shown in Fig.3.
This device complies FCC Rules for HOME OR OFFICE USE. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Fig.1
Fig.3
Fig.2
LEARN
30
seconds
OK
1
Visor Clip
Holster
Signal and Battery
Indicator
2
OK
3
x2
x2
23AE 12 Volt Alka-
line Battery