User's Manual

WARNING

To prevent SERIOUS INJURY or DEATH from electrocution:

- Power MUST NOT be connected until instructed.

To prevent SERIOUS INJURY or DEATH from using the Door Control Console or Push Button and a clos-

ing door:

- Install the Door Control Console or Push Button within sight of the door at a minimum height of 5 feet

(1.5m) above the floor. Make sure it is out of the reach of children and moving parts of door and hard-

ware.

- NEVER permit children to access the Door Control Console , Push Button or Remote Controls.

- Operate the door ONLY when it is adjusted properly with no obstructions present and is in clear sight.

- ALWAYS keep a moving door in sight until it’s completely closed.

- NEVER cross the path of a moving door.

Connecting Door Control Console

To Connect the Door Control Console to the Opener

Connect the pair of wires from the Door Control Console to the

pair of “PUSH BUTTON” terminals on the rear of the Opener.

Refer to Wiring Instructions on page 12 to ensure wires are

properly connected.

Door Control

Console

Min. 5 feet (1.5m)

above floor

From Door Control

Console

Drywall Anchor

Screw #6 x1-3/8”

In this carton, a Door Control Console has replaced the standard

push button as the wired, illuminated door control to be placed

inside the garage.

To install the Door Control Console:

1. Lift the large actuator cover on door the control console and

the upper screw post is exposed

2. Position the door control console at minimum height of 5 feet

(1.5m) above the floor to keep out of the reach of children, within

sight of door and free from any moving parts on the door.

3. Mark the position of both upper screw post and lower screw

hole on the door control console.

4. Fasten the bottom screw to a solid surface with 1” screws. If

attaching to drywall or other hollow surface, drill 3/16” holes and

use the provided Drywall Anchors.

5. Align the bottom hole with the bottom screw. Slide the door

control down into place.

6. Repeat #4 to secure the door control console with the upper

screw

7. Flip down the actuator cover back into place