User's Manual

12
!
WARNING
To prevent SERIOUS INJURY or DEATH from electrocution:
- Disconnect power cord before installing/replacing light bulb.
To prevent possible OVERHEATING or damage to Opener:
- Use ONLY A19 (E26) incandescent bulbs (100W max.).
- DO NOT use short neck or specialty light bulbs.
- DO NOT use halogen bulbs.
Safety Notice
Mount the emergency release within reach, but at least 6 feet
above the floor and avoiding contact with vehicles to avoid acci-
dental release.
To attach the Emergency Release Handle:
1.
Thread one end of the rope through the hole
of the
Emergenc
y Release Handle and secure with an overhand
knot.
2.
Thread the other end of the rope through the hole
in the
Trolley lever.
3.
Measure the rope length so that the handle is 6 feet
(183cm) above the floor and is clear fr
om the top of your
vehicle. Secure with a o
verhand kn
ot.
Fig. 2
!
WARNING
To prevent SERIOUS INJURY or DEATH from a falling garage door:
- In case of power failure or door obstruction, PULL EMERGENCY HANDLE to release door from Open-
er.
- When Emergency Release is in the released position, the door can be operated manually.
- To reconnect, flip the lever on the Trolley towards Opener, back to Connect position, it will reconnect
automatically upon pressing Push Button or Remote Control.
- DO NOT use Emergency handle to pull the door open or closed.
Installing Light and Emergency Release Handle
6 feet (1.83m) above floor
Lever
Emergency Release Handle
Fig. 2
To install light bulb as shown in Fig.1:
1.
Install a standard A19 (E26) 100 watt
maximum light bulb.
2.
Re-attach the Lamp Dome.
To replace light bulb as shown in Fig.2:
1.
Press the release buttons and detac
h it
from the Ope
ner.
2.
Replace light
bulb and reattach the
lamp dome.
N
otice
When replacing the light bulb, make sure the
bulb on the Opener has cooled down to pre-
vent injury.
1
2
Fig.1
2
1
0
0
W
M
A
X