User's Manual

20
In case of a power failure or door obstruction, PULL
EMERGENCY Handle to release door from Opener.
To Disconnect Trolley for Manual Operation
With the door closed, pull down the emergency release Handle
to the DISCONNECT position. The door can be raised / lowered
manually.
To Re-connect Trolley
Pull the Handle toward the Opener so that the lever will flip up
to the CONNECT position. The Trolley will reconnect itself when
the Opener is activated or when the door is manually opened/
closed
Operation / Condition Courtesy Light Response
Opener is initially plugged-in / Power restored Flashes 5 times
Upon Opener activation Turns on for 4-1/2 minutes and turns off automatically
“LEARN” button is pressed Turns on for 30 seconds
Remote Control / Keyless Entry PIN code accepted Flashes 5 times
The Photo Eye System is obstructed during door-closing or
door is obstructed during opening
Flashes for 30 seconds (Re-align and clear obstruction)
Opener motor overheat (Thermal Protection) Flashes 5 times (Wait about 15 minutes to cool down)
Courtesy Light Responses
Manual Operation
Door status
Activation using Push Button / Remote Con-
trol
Door at fully open / close position Door will move to fully close / open position
Door is closing Door will reverse
Door is opening Door will stop
Door is stopped as intended in partially open position Close
Door is obstructed while closing Door will reverse while flashing courtesy light
Door is obstructed while opening Door will stop
Door is fully opened and Photo Eye System is obstructed Door will not close
Door Status vs. Activation
Operating the Opener
!
WARNING
To Prevent SERIOUS INJURY or DEAT
H:
- Use Emergency Release to disconnect Trolley ONLY when the door is CLOSED to prevent unexpected rapid falling in
case of a unbalanced / poor-conditioned door.
- Use Emergency Release ONLY when doorway is clear of persons and obstructions.
- DO NOT use Emergency Release to pull the door open or closed.
Lever
CONNECT
DISCONNECT
Pull to Disconnect
Flip to reconnect