Product Manual

Installation and Use
Guardian Fall Protection 6305 S. 231st St., Kent, WA 98032 phone: [phone] fax: [phone] www.guardianfall.com
11
1. All components of the personal fall arrest system must be selected and deemed compatible
with Velocity SRL by a Competent Person.
2. Ensure structure to which Velocity SRL is to be attached, and on which work is to be
performed, is free of all hazards, including, but not limited to, debris, rot, rust, sharp or abrasive
edges and surfaces, and hazardous materials.
3. Use:
• In non-LE applications, Velocity
SRL may be attached to anchorage connector or harness
dorsal D-ring. Velocity SRL must always be positioned at or above harness dorsal D-ring
AND at or below anchorage connector.
• In LE applications, Velocity SRL must be attached to anchorage connector, and may be
positioned a maximum 2’ below harness dorsal D-ring.
4. Ensure 100% tie-off will be maintained at all times, which may require the use of a back-up
or supplementary fall protection system.
Velocity SRL part #s: 42006 and 42008 may NEVER be used in LE applications.
Velocity SRL part #s: 42000, 42001, 42002, 42003, 42004, and 42005
may be used in LE applications ONLY if used in combination with shock
absorber extension deemed compatible with SRL by a Competent Person.
If intending to use Velocity SRL in LE applications,
refer to additional LE SRL use instructions (pg. 12).
ALWAYS avoid lifeline contact with sharp or abrasive edges and surfaces.