User's Manual

Installation Guide
Guardian 6200
Copyright © 2006 Guardian Mobile Monitoring Systems, Inc. All rights reserved.
www.guardianmms.com
5 Optional Auxiliary Input and Panic Button
Auxiliary Input
• The Auxiliary input can be used to detect and report a
change of voltage – both low to high and high to low.
Connect a switch or relay from your alarm system
or any other switched device to be monitored. When
closed, the switch must connect 12 Volts power to pin
10 (white wire) of the wiring harness connector. When
open, the switch must connect pin 10 of the wiring
harness to ground (0 Volts) or to nothing at all.
Panic Button
• Following the wiring diagram, connect a panic button
to pin 6 (green wire) of the wiring harness connector,
connect the other terminal of the button to 12V power.
The Panic button must be a momentary contact
switch that connects 12 Volts power to pin 6 when it is
pressed.
A auxiliary input and/or panic button may be connected to the beacon.
6 Test
• For the first test, the vehicle should be outdoors in an open area where GPS signals can be readily received
• Watch the indicator LED on the beacon for the first few minutes after all power and antennas have been connected.
It indicates the following status:
• Ensure that the indicator LED is showing flashing orange.
• Perform an end-to-end system test by locating the beacon via the user portal
Color/Action Function
Green/Steady GSM Connection established
Green/Flashing GPRS Data being transferred
Orange/Steady Searching for satellites – no fix
Orange/Flashing GPS fix acquired
NOTE
It may take up to an hour for the
wireless network and the GPS
receiver to synchronize the first
time the beacon is powered up.
• Connect the two antenna cables to the beacon
using the corresponding coaxial connectors
• Attach the wiring harness to the beacon and ensure
that the retaining clip snaps in place
• Affix the beacon securely to the vehicle using the
mounting plate and screws provided. Drill mounting
holes as required
• If a suitable panel for affixing the supplied mounting
plate is not available, fastening the beacon to a
bracket or wire bundle with plastic cable ties is also
adequate
• Coil and secure any loose or extra length wire
4 Connect and Mount Beacon