Product Name: Ridge-It Anchor Part #: 00500; 00510; 00515 Instruction Manual Do not throw away these instructions! Read and understand these instructions before using equipment! Introduction 1 Applicable Safety Standards 1 Worker Classifications 1 Product Specific Applications 2 Limitations 2-3 Components and Specifications 3 Installation and Use 4-5 Maintenance, Cleaning, and Storage 5 Inspection 6 Inspection Log 6 Safety Information 6-7 Labels 7
User Information Date of First Use: Serial #: Trainer: User: Applicable Safety Standards When used according to instruction specifications, this product meets or exceeds all applicable OSHA 1926 Subpart M, OSHA 1910, ANSI Z359.1-2007, and ANSI A10.32-2012 standards for fall protection. Applicable standards and regulations depend on the type of work being done, and also might include state regulations if applicable.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 Guardian Fall Protection Product Specific Applications ! WARNING Use of equipment in unintended applications may result in serious injury or death. Maximum 1 attachment per connection point. Personal Fall Arrest: Ridge-It Anchor may be used to support a MAXIMUM 1 PFAS for use in Fall Arrest applications. Structure must withstand loads applied in the directions permitted by the system of at least 5,000 lbs.
Two connectors to same D-ring. NO. Application that places load on gate. NO. Incompatible or irregular application, which may increase risk of roll-out. NO. Connector directly to horizontal lifeline. NO. Correct Anchorage Positioning: This chart details allowable working zones required to reduce risk of swing falls and improper side loading. ALWAYS adhere to information specified by chart.
www.guardianfall.com Installation and Use ! WARNING For permanent installation applications ONLY. Ridge-It Anchors must NEVER be reinstalled. Guardian Fall Protection 6305 S. 231st St., Kent, WA 98032 phone: (800) 466-6385 fax: (800) 670-7892 Prior to installation, plan your system: 1. Ensure all PFAS equipment is selected and deemed compatible with Ridge-It Anchor by a Competent Person. 2. Select installation location for Ridge-It Anchor.
3. Bend Ridge-It Anchor at its center so it will fit snugly over selected installation location. www.guardianfall.com 2. Butyl Strips function to provide weather resistance and waterproofing, thereby allowing Ridge-It Anchor to be installed directly on roof surface without removing ridge cap/roof shingling. It is permitted to install in a retrofit application beneath ridge cap/roof shingling; if doing so, remove all applicable ridge cap/roof shingling at selected installation location. 5.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 Guardian Fall Protection Inspection Prior to EACH use, inspect Ridge-It Anchor for deficiencies, including, but not limited to, corrosion, deformation, pits, burrs, rough surfaces, sharp edges, cracking, rust, paint buildup, excessive heating, alteration, broken stitching, fraying, and missing or illegible labels.
A pre-planned rescue procedure in the case of a fall is required. The rescue plan must be project-specific. The rescue plan must allow for employees to rescue themselves, or provide an alternative means for their prompt rescue. Store rescue equipment in an easily accessible and clearly marked area. Training of Authorized Persons to correctly erect, disassemble, inspect, maintain, store, and use equipment must be provided by a Competent Person.
