User's Manual

OPERATING TEMPERATURE

Your watch is designed to work and be stored in ambient temperatures between –10 

C and 45 C (14 F and 113 F). Your watch can be damaged and battery life shortened

if stored or operated outside of these temperature ranges. Avoid exposing the watch

to dramatic changes in temperature or humidity.

REGULATORY COMPLIANCE INFORMATION

This section introduces regulatory information, certiﬁ cation, and compliance

information speciﬁc to your product.

ELECTROMAGNETIC FIELDS (EMF)

This product complies with all applicable standards and regulations regarding

exposure to electromagnetic ﬁelds.

FCC WARNING

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired

operation.



NOTE 1: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.



NOTE 2: Any changes or modiﬁcations to this unit not expressly approved by the

party responsible for compliance could void the user's authority to operate the

equipment.