User's Manual
E-Kanban Call Button Installation and Configuration Guide
Mounting the E-Kanban Call Button
07-00090-001 ©2017 Guard RFID Solutions Inc. All Rights Reserved 5
Mounting the E-Kanban Call Button
The E-Kanban Call Button is a robust device designed for industrial environments, and can be
mounted to a hard surface or left unmounted for portability (although this latter option will make
wired power difficult).
Note that mounting the device usually makes it difficult to access the back of the device. Be sure
to insert batteries/wire the device to power, and to record the device’s serial number, before
mounting it.
Bolts or screws
The E-Kanban Call Button can be mounted to a
solid surface using screws or bolts. Thread the
bolts through the holes at either end of the
device. Note that you will have to unfasten the
device to access the battery compartment or
connectors.
Tie wraps
The E-Kanban Call Button can be mounted to a
post or grate using tie wraps. Thread the tie
wraps through the slots at either end of the
device. Note that you will have to cut the tie
wraps to access the battery compartment or
connectors.
Adhesives
You can mount the E-Kanban Call Button to a surface using double-sided adhesive pads, but this is
not typically recommended. Although adhesive pads will not damage the device and can provide
secure mounting, they are also more difficult to remove than fasteners and may obscure the
device serial number label. Use this method only if you do not need to regularly access the back of
the device (i.e., if you are primarily using wired power).